Rf267aers manual

How To Do Page 32 6. Disconnect the water tube by pushing the tube fitting apart as shown in the picture. The other Water Tube is located in the Top Table of the refrigerator. Before disassembling the Water Tube, take out the Top table. Water Tank 7. Remove the cool select pantry. Remove the screw part of lower motor damper part and then push the motor damper down.

Motor Damper 2. Disengage 2 housing connectors from the rear motor damper. Water Filter 2. Turn the water filter counterclockwise until central horizontal line of filter cover and both ends of water filter label Remove 2 screw cap parts with a flat-blade - screwdriver.

Refer to the picture 2. Unscrew 2 screws. Vertical Hinged Section 3. Disengage the internal housing connector of the vertical hinge. Remove the angle cap with a flat-blade screwdriver.

Unscrew 4 screws. Remove the the lower part of angle mid by pulling it out and Evaporator Cover pushing it down. Remove the the housing cover by pushing both lateral sides of the housing cover and pulling it out. Disconnect the housing connector part. Open the freezer door. Remove the tilting pocket by pushing it to the left. Remove the 2 support tilting pockets with temporary force. Refer to the picture 3. Slide the drawer in as much as possible Door Handle 2.

Lift the drawer up Freezer 3. Remove the pull out drawer by lifting the bottom part of drawer bin and pulling it out. How To Do Descriptive Picture Pull the Ice-Bucket lever and out 2. Remove 1 screw of the Cover 3. Disassemble the cover with a flat-blade - screwdriver and pull it out. Ice Maker 4. Disengage the 2 housing connector. When installing, servicing or cleaning the back of the Samsung RS25HSR refrigerator, be sure to pull and push it straight.

Easily move the refrigerator to its final location by measuring doors width and height , thresholds, ceiling heights, stairs, etc.

Be sure to disconnect the main water supply before removing the door from the freezer. Refer to the chapter 'removing the water supply from the refrigerator' to avoid any damage on page 12 of this Samsung RS25HSR Manual. If it is necessary to remove the doors from the refrigerator to fit it, replace the doors and install the handles. Take the handles on the right side of the door. Orient each handle so that the end with the sticker is up and the holes with the clamping screws are facing each other.

If the LED is on or flashing the main board is OK and the rest of the tests can be done at the inverter board. On the inverter board locate the 3 wires, blue, purple, and black, going to the compressor and check for about 10 ohms between any 2 of those wires. If those tests pass and the LED is blinking or3 times replace the inverter board. If the LED is blinking or 6 times replace the compressor and inverter board.

This power control board is a replacement part for a refrigerator. The power control board is located in the back of the refrigerator. The purpose of a power control board is to maintain and manage the refrigerator's Thanks Jake, I'll replace the inverter board and see what happens. It may take a week or more to arrive. My family is living out of a dorm fridge until then.

CN01 red and gray measured All 3 of those checks seems good so I'll wait for the inverter board. If that doesn't fix it I will assume bad compressor and since this is 8. Ok, yes the new inverter board should fix it. If you would like to schedule service and have a qualified technician help you, I have also attached a link to searshomeservices.

I hope these links will help until your expert can respond. Want to get updates on new answers? Answer this question. Didn't find what you are looking for? Related Questions. Popular Products in Samsung. Samsung 7" Galaxy Tab 4 Android 4.

See Details.