Page 37 7. Press E while C-C. PS appears. One of the following Pager Screen options appears. PS On: The scanner ignores hits on common pager frequencies. Repeatedly press want appears, then press E to select it. You can also change each range to a range you set. Page Chain Search Hold Mode Press to enable or disable the search bank number being searched in this mode. Enabled bank numbers appear.
Disabled bank numbers disappear. At least one search bank must be enabled. The scanner sounds an error tone if you try to disable all the search banks. Page Direct Entry Search The scanner sets itself to program mode after you store a frequency.
Setting the Search Range You can use this mode to define the search range used during a search in each search bank.
To change a search range, press Func and PSrc. SRCH appears. Enter the frequency you want to start from by using the number keys. Press decimal point. If you enter a frequency that is out of range, the scanner sounds an error tone and Error appears. The frequency and lowest blank channel alternate on the display. Page Delay memory and automatically resumes the search if it is not in hold. Follow these steps to clear a single frequency from skip memory so the scanner stops on it during a search.
Press Hold to stop the search. When the delay feature is on, DLY appears. If it is off, follow one of these steps to program a delay depending on how the scanner is operating,.
One bank must always be active. Locking Out Channels You can increase the scanning speed by locking out channels that have a continuous transmission. Page Using Keylock Follow these steps to select a different channel in a bank as the priority channel. Manually select the channel you want to select as the priority channel. One or more channels might be locked out. The channel might not be active. Page Resetting The Scanner Resetting the Scanner If the scanner's display locks up or stops operating properly, you might need to reset the scanner.
Caution: This procedure clears all the information you have stored in the scanner. Before you reset the scanner, try turning it off and on to see if it begins working properly.
If it gets wet, wipe it dry immediately. Use and store the scanner only in normal temperature environments. Handle the scanner carefully: do not drop it. Keep the scanner away from dust and dirt, and wipe it with a damp cloth occasionally to keep it looking new. Repairs Do not attempt any repair. The scanner contains no user serviceable parts.
Contact the Uniden Customer Service Center or take it to a qualified repair technician. The scanner is versatile, compact, and easy to use. This handheld scanner with full frequency display offers programmable memory channels — 7 bands.
It does take a little investment time to work out its … The scanner has three band plans, which are useful for major regions in Europe. To change the Band Plan, press and hold the band plan number 1, 2 or 3 while turning On the scanner, Note: This scanner remembers the last band plan. The chart below identifies the scanner band numbers, the frequency range, the modulation Uniden SR30C handheld scanner. In addition to its standard scanning features, your scanner also… View full details 9.
KHz: Frequency stability:? Handheld Scanner. This radio has a 3. Its a full 8. What is Searching? The scanner will scan multiple Favorites Lists and Full Database at the same time. Read online or Manual ver. Eject the microSD card and place back into your AppCam. Connect the power to your AppCam. The AppCam will install the firmware. Note: It may be necessary to perform the initial setup again for the AppCam and your mobile phone application.
This installer creates the following driver on your system: v2. Install Instructions. You will need this to unlock the full version of the program. There is no charge for the full version of this software. Release Notes.
0コメント